Build a water-leak alarm for under the sink (ESP32, one evening)

Mahdi Mansouri — Thu, 15 Oct 2026 18:27:47 +0000

"How do I get warned before a leak under the sink floods the kitchen?"

Water conducts a little electricity. Two metal contacts a few millimetres apart on the cupboard floor, a small board that checks them, a loud buzzer and a phone alert. The test is dramatic: pour a glass of water and it screams.

Cost $6–12 · Time one evening · Level first build · Power USB or battery

What to buy

Part	Why this one	Rough cost
ESP32-C3 board	Small, cheap, WiFi built in.	$4–7
Leak probe: two wires or two screws, a few mm apart	Or a cheap "rain sensor" board with a comparator, which gives a simple wet/dry signal.	$0–2
Active buzzer	Beeps by itself when powered, so no tone code is needed. It still warns you when your phone is off.	$1
A 100 kΩ resistor	For reading the probe (see step 1).	$0.10
USB power (there's often a socket under the sink) or batteries		—

Prices are rough ranges, not quotes. Check the current price and stock before you order.

What to install

ESPHome or a short Arduino sketch: check the probe, sound the buzzer when it's wet, and send a phone alert through ntfy or Home Assistant. Repeat the alert every few minutes until it's dry; a leak is urgent.

Ready-made option: leak sensors for Zigbee or WiFi cost about $10–20. Build your own to learn, or to get a loud buzzer right at the sink.

Build it in three steps

Test with a glass of water. Connect one probe to ground. Connect the other to an analog pin, and through the 100 kΩ resistor to a second pin that you switch on only while measuring. Print the reading dry, and with the probe in water: wet should read clearly lower.
Add the buzzer and the alert. Drive the buzzer from a pin (through a small transistor if it needs more current than a pin can give). Alert once when it turns wet, then every few minutes.
Place it. Probes flat on the lowest point of the cupboard floor; board and buzzer higher up, where they stay dry.

What catches people out

Probes corrode if they're powered all the time. Constant current through wet metal eats it away. Power the probe only for the moment you measure, which is why the resistor goes to a pin, not straight to 3.3V.
Damp isn't a leak. Set the alert point from your own test, well away from the dry reading.
Battery version: wake every 30–60 seconds, check, sleep. A leak takes minutes to do damage, so that's fast enough.
Low voltage only. USB or batteries; never run mains wiring near the water.

This guide first appeared on IotMentor, a free chat mentor for small electronics builds (I make it). If your setup is different (distance, power, budget, experience), you can ask it there and it will plan your version.

DEV Community: Mahdi Mansouri

Build a water-leak alarm for under the sink (ESP32, one evening)

What to buy

What to install

Build it in three steps

What catches people out