Logging Appliance Current with a Clamp Meter and a Few Lines of Python

MiniDigitalC — Fri, 23 Oct 2026 08:31:55 +0000

I work with MiniDigitalC (minidigitalc.co.uk), a UK store for clamp meters and electrical test tools. This post shares a practical measurement + logging workflow; the product link at the end is to a tool we sell.

If you build home-automation or energy-monitoring projects, you need real numbers before you size relays, fuses or current sensors. A handheld clamp meter is the quickest way to get them: no cutting wires, no series shunt. Here is a simple workflow for capturing manual readings and turning them into useful data.

Why measure first?

Datasheet power figures are often nominal. Motors have inrush, LED drivers and switch-mode supplies draw distorted, non-sinusoidal current. A True RMS clamp meter reports the effective value, which is what your relays and cables actually experience.

Safe measurement setup

Never open mains equipment unless you are competent to do so.
Use a line splitter between the socket and appliance so you can clamp a single conductor. Clamping the whole flex reads roughly zero because live and neutral cancel.
For DC projects (12V LED strips, battery banks), select DC amps and zero the meter first.

Capture readings

Take a reading every minute through the appliance's cycle and log them:

import csv, datetime

with open("current_log.csv", "a", newline="") as f:
    w = csv.writer(f)
    while True:
        val = input("Amps (blank to stop): ").strip()
        if not val:
            break
        w.writerow([datetime.datetime.now().isoformat(), float(val)])

Analyse

import pandas as pd
df = pd.read_csv("current_log.csv", names=["ts", "amps"], parse_dates=["ts"])
print("peak:", df.amps.max(), "A")
print("mean:", round(df.amps.mean(), 2), "A")
print("est. kWh:", round((df.amps.mean() * 230 / 1000) *
      (df.ts.max() - df.ts.min()).total_seconds() / 3600, 3))

The kWh estimate assumes 230V and unity power factor, so treat it as a rough guide.

Use the data

Size your relay with headroom above the observed peak.
Choose a CT sensor range for your ESP32/Raspberry Pi monitor that covers the peak without wasting resolution.
Compare against your smart plug's reported values to calibrate it.

Tooling note

A compact AC/DC True RMS meter such as the UNI-T UT210E mini clamp meter is handy here because it fits small enclosures and covers DC for low-voltage builds.

Measure, log, then design. Your projects will be safer and better sized.