A Berachain bridge route that swaps into a different token needs a slippage tolerance you can accept: start around 0.5% for stablecoin pairs and raise it gradually for volatile or thin pairs such as ETH to BERA. For more on moving assets between chains, use the Berachain bridge, a cross-chain asset bridge for transfers involving Berachain. Slippage tolerance sets the minimum amount the swap can deliver; too low a setting can stop or reroute the swap, while too high a setting can leave you with a poor price.
How Do You Set Slippage on a Berachain Bridge Swap?
To set slippage on a Berachain bridge swap route, have your wallet connected and a quote for the token you want to receive. The route must include a swap. A same-token transfer has no swap leg, so swap slippage does not apply.
- Open the selected route’s settings and find slippage tolerance. This identifies the percentage that will govern the swap.
- Enter a tolerance that fits the pair. For a stablecoin-to-stablecoin swap, such as USDC to HONEY when both trade near their pegs, start around 0.5%. For ETH to BERA or a thin pair, raise it in small increments only if the quote needs more room to execute. The updated quote shows the effect of your choice.
- Read the quoted minimum received in the destination token. This is the amount to judge, because a percentage alone does not tell you how much BERA, HONEY, or another token you could receive.
- Confirm only when that minimum matches what you are willing to accept. Your chosen tolerance and acceptable minimum received are the completed setting.
Take two ETH-to-BERA swaps for the same amount of ETH. A route with deeper pool liquidity may show modest price impact; a route with thinner liquidity may quote much less BERA before slippage is even applied. Trade size relative to pool liquidity drives price impact. Raising tolerance gives the second swap more room to execute, but it does not improve its quoted price. If its minimum received is unacceptable, reduce the amount or seek a more liquid route.
Large swaps deserve particular care. A very high tolerance can let a swap execute at a much worse price and creates room for sandwich trades. Increase the setting only as far as the route requires, then reassess the minimum received.
Related Questions
What Happens If a Bridge Swap Exceeds Slippage?
A bridge swap that exceeds tolerance may fail or be rerouted. On many aggregator routes, the cross-chain transfer has already happened when the Berachain-side swap fails. In that case, you receive the bridged intermediate token instead of your intended final token; the entire transfer does not simply reverse. You would then need to decide when and how to swap that intermediate token. Read the route’s fallback terms before confirming so you know which asset you may hold if the final swap cannot execute.
Is Slippage the Same as the Bridge Fee?
Slippage is the price movement a swap may accept between quote and execution. A bridge fee is a charge for the cross-chain transfer. Assess the fee separately, then use minimum received to decide whether the complete route delivers enough of your destination token.
Top comments (0)