DEV Community

Convertola
Convertola

Posted on

Why your MP4-to-MP3 file sounds worse than the video (and how to avoid it)

You pull the audio out of a concert clip or a screen recording, play the MP3, and something is off: it sounds thinner, quieter, or a bit "swishy" compared with the video. The converter usually is not broken. Most of the time it comes down to three things you can control.

1. The audio inside the MP4 was already compressed

An MP4 almost always carries AAC audio, often at 128 kbps or less on phone recordings and social media downloads. Converting to MP3 means decoding that AAC and encoding it again. Every extra lossy step throws away a little more detail, so the trick is to give the MP3 encoder enough room:

  • Speech (lectures, meetings, voice notes): 96–128 kbps is plenty.
  • Music from a decent source: 192 kbps keeps it clean.
  • 320 kbps only helps if the MP4 audio itself was high quality. It will not restore what the original never had.

2. Volume changes between video players and music players

Video players and streaming apps often apply loudness normalisation; plain music players usually don't. The MP3 is not quieter, it is just played back without that boost. If it really is too quiet, normalise it once in an audio editor rather than reconverting at a higher bitrate.

3. Mono vs stereo surprises

Phone videos are sometimes stereo with one silent channel, or mono that gets duplicated. If your MP3 sounds like it comes only from one earbud, check the channel layout before converting and down-mix to mono for speech.

A quick routine that works

  1. Use the original MP4, not a re-downloaded or re-shared copy (messaging apps recompress).
  2. Pick the bitrate by content, as above.
  3. Listen to the first and last minute of the MP3 before deleting anything.

Full disclosure: Convertola is our own project. If you want to extract audio from an MP4 video without installing anything, the converter runs in the browser, lets you pick the bitrate and gives you the MP3 straight back. If the video lives on your phone, there is also a short walkthrough on converting on an iPhone. Prefer the terminal? ffmpeg -i clip.mp4 -vn -b:a 192k clip.mp3 does the same job.

Short version: start from the original file, choose a sensible bitrate once, and keep the MP4 until the MP3 checks out.

Top comments (0)