DEV Community

ke ja
ke ja

Posted on

Will It Fit? Comparing Tire Sizes With the Numbers That Actually Matter

Will It Fit? Comparing Tire Sizes With the Numbers That Actually Matter

Every tire forum thread starts the same way: "I'm running 225/65R17, can I switch to 265/70R17?" The honest answer is a handful of numbers, and TireCalcPro.com exists to put all of them on one screen: overall diameter, sidewall height, circumference, revolutions per mile, and what the change does to your speedometer.

A worked example

The stock 225/65R17 stands 28.5 inches tall. The 265/70R17 stands 31.6 inches — over 10% larger. The old rule of thumb says stay within ±3% of the original diameter, and this swap blows through it: when the speedometer reads 60 mph you'd actually be doing about 66, the gearing effectively gets taller, and the tire needs room the wheel arch may not have. None of that is visible from the size codes alone, because the codes hide the arithmetic: width in millimetres, sidewall as a percentage of that width, wheel in inches — three unit systems in one label.

See it in the arch

The piece I built that I haven't seen elsewhere: the new tire drawn inside your wheel arch, with the change in gap shown to scale and coloured by the real numbers — because "will it rub?" is a geometry question, and geometry is easier to judge with your eyes than with a spec table. Compare two sizes side by side, check the speedometer error, then look at the arch before you spend anything.

Links

Top comments (0)