DEV Community

Khalid Balouch
Khalid Balouch

Posted on

D-Link DIR-806A Rev A1 Login - Default Gateway and Credentials

The D-Link DIR-806A Rev A1 is an AC750 dual-band router — 2.4 GHz and 5 GHz in one box — and like most D-Link hardware it hides its settings behind a small web page at a fixed address. If you need to change the Wi-Fi password, check who is connected or update the firmware, the login below is the way in.

How to log in to the DIR-806A Rev A1

  1. Connect to the router by Wi-Fi or Ethernet. The factory network names are DIR-806A for 2.4 GHz and DIR-806A-5G for 5 GHz.
  2. Open a browser and go to http://192.168.0.1 in the address bar. You can also type http://dlinkrouter.local — both open the same login page.
  3. Enter admin as the username and admin as the password. On a first login the router may ask you to set a new admin password instead — do that, and write it down.
  4. Click Log In. The setup wizard or the main dashboard opens.

The full model guide, with the steps and fixes in order, is on WiFi Router Zone.

What you can do inside the panel

Once you are in, the useful pages are the wireless settings, where you change the network name and Wi-Fi password on each band; the DHCP client list, which shows every device on your network; and the management or firmware section, where you check for updates and reboot the router. Change the Wi-Fi password first if the router is still on its factory settings, and write the new password down before you save it.

Troubleshooting

The page never loads. Make sure you are connected to the DIR-806A itself, not mobile data or another network, and check the address — D-Link uses 192.168.0.1, not 192.168.1.1. On Windows, ipconfig shows your real gateway on the Default Gateway line. Note that dlinkrouter.local only works while you are connected to the D-Link router. The same check-the-gateway-first habit applies to every brand — see our Hathway router login guide for another worked example.

The login is rejected. Passwords are case-sensitive, so check Caps Lock. If the admin password was changed and forgotten, press and hold the recessed reset button for about 10 seconds, wait for the router to restart, then sign in again with admin / admin and run the setup wizard.

Still stuck? If your unit is a different DIR-806A hardware revision, check the label on the bottom or back of the device — the gateway address and default credentials are printed there, and the label always wins over any guide.

Top comments (0)