DEV Community

Khalid Balouch
Khalid Balouch

Posted on

OptiLink Router Login: Find Your Model's Default Password

OptiLink routers are common on Excitel and other fibre connections in India, but finding the right login details can be confusing — because there is no single OptiLink password. The credentials depend on your exact model, and using the wrong ones will just keep you locked out.

The OP-XONT 71110AC login

For the widely used OP-XONT 71110AC, open a browser on a device connected to the router and go to 192.168.1.1. The default username is excitel and the default password is exc@123. Note the password carefully: it is exc, then the @ symbol, then 123 — a small typo here is the most common reason the login fails.

For the full model-by-model guide, see https://wifirouterzone.com/brand-login/optilink-router-login/

Check the model on the label first

Before you try any password, look at the sticker on the bottom or back of your OptiLink router and find the model number. Other OptiLink models use different usernames and passwords, so a combination that works for one model may fail on another. The label is also where you will find the router's default IP address if it differs from 192.168.1.1, plus the default WiFi name and password.

If the login page will not open

First, make sure you are connected to the OptiLink router itself — by WiFi or an Ethernet cable — and not to mobile data or another network. Then check your device's default gateway: if it shows 192.168.1.1, that address should open the login page. If it shows something else, use that address instead. If the page still will not load, restart the router and wait a couple of minutes before trying again.

If the password is rejected

If excitel and exc@123 are rejected on an OP-XONT 71110AC, the password may have been changed during installation — your ISP's technician sometimes sets a custom one. Check the label for any handwritten or printed alternative, and ask your ISP if you are unsure. As a last resort, a factory reset (hold the reset button for about 10 seconds) restores the defaults, but it also erases your WiFi settings, so only do this if you can set the connection up again.

After you log in

Once inside, change the admin password and your WiFi password to something only you know. Default credentials are widely published, so leaving them unchanged means anyone connected to your network could open the admin page and change your settings. If you want a refresher on the wider topic, the earlier guide to KT router login covers the same habit of checking the gateway address before guessing credentials.

Top comments (0)