Free Klipper pause, resume and cancel macros for the Ender-3 S1

Paste into a file called macros.cfg, add [include macros.cfg] to printer.cfg, and restart firmware. Needs [virtual_sdcard], [pause_resume] and [display_status] in your config. Remove any older PAUSE/RESUME/CANCEL_PRINT macros first.

These macros use END_PRINT for cancel; define your own or replace that line with TURN_OFF_HEATERS.

[gcode_macro PAUSE]
description: Pause, retract and park
rename_existing: BASE_PAUSE
gcode:
    {% set z = params.Z|default(10)|int %}
    {% if printer['pause_resume'].is_paused|int == 0 %}
        SAVE_GCODE_STATE NAME=PAUSE_state
        BASE_PAUSE
        G91
        G1 E-2 F2100
        G1 Z{z} F900
        G90
        G1 X10 Y10 F6000
    {% endif %}

[gcode_macro RESUME]
description: Return to position, unretract, resume
rename_existing: BASE_RESUME
gcode:
    {% if printer['pause_resume'].is_paused|int == 1 %}
        G91
        G1 E2 F2100
        G90
        RESTORE_GCODE_STATE NAME=PAUSE_state MOVE=1 MOVE_SPEED=100
        BASE_RESUME
    {% endif %}

[gcode_macro CANCEL_PRINT]
description: Cancel and run the end routine
rename_existing: BASE_CANCEL_PRINT
gcode:
    TURN_OFF_HEATERS
    CLEAR_PAUSE
    SDCARD_RESET_FILE
    END_PRINT

[gcode_macro Z_OFFSET_UP]
description: Nudge live Z offset up 0.02 mm
gcode:
    SET_GCODE_OFFSET Z_ADJUST=0.02 MOVE=1

[gcode_macro Z_OFFSET_DOWN]
description: Nudge live Z offset down 0.02 mm
gcode:
    SET_GCODE_OFFSET Z_ADJUST=-0.02 MOVE=1

[gcode_macro COOLDOWN]
description: Everything off
gcode:
    TURN_OFF_HEATERS
    M106 S0

Want the rest?

The Klipper Macro Pack adds START_PRINT (adaptive mesh, prime line), END_PRINT, LOAD/UNLOAD_FILAMENT, PID shortcuts, PARK and more, plus slicer start/end gcode: https://spectre5.gumroad.com/l/lkjfl ($6)

More guides: https://patreon.com/123black

Use at your own risk. Not printer-tested by the author on every machine. Not affiliated with Creality.