Most of the line arrays that pass through my hands are ex-rental, and ex-rental boxes tell you a lot if you know where to look. Last month I spent an afternoon going over a small set of Meyer Sound LEOPARD cabinets that came out of an installed corporate AV system, and the process makes a decent template for anyone evaluating compact arrays for a venue or a small rental inventory.
What the box actually is
The LEOPARD is a two-way compact array with two 10-inch LF drivers and a rated 135 dB peak. That number matters less than what it implies: this is a cabinet built to cover a corporate general session or a mid-size room without a truck full of boxes, and it does it with a forgiving vertical pattern when you keep the array short. Two per side is a common starting point. Four per side gets you into rooms where you'd otherwise be flying something much bigger.
Inspection order
I start with rigging, not sound. These cabinets were flown with MILO rigging hardware, which is a mixed blessing. It's well understood and spares exist, but it also means the frames and pins have been under static load for years. Look for bent pins, ovalised holes, and any frame that has been re-drilled. A box that has hung in a fixed install often has less cosmetic wear than a touring cabinet, but the rigging has been loaded continuously the whole time.
Next: grille and foam. Backing that has gone sticky or crumbly is a cheap fix, but it tells you about the environment the box lived in. Then cones and surrounds, then a sweep.
Electrical and acoustic checks
Bring a measurement rig. An impedance sweep per band will show a dragging driver or a tired diaphragm long before it becomes audible as distortion. I also run a slow sine sweep at moderate level and listen for rattles in the enclosure and hardware, because installed boxes pick up loose fasteners from years of nearby HVAC vibration.
The honest caveat
Grade A means excellent used condition, not new. Expect scuffs on the cabinet edges and a grille that has been re-seated at least once. What you should not accept is a driver out of spec, mismatched HF diaphragms, or missing rigging components. Those are the things that turn a good-looking listing into a bad day.
The set I went through is a 2019 build, eight units in stock with a two-cabinet minimum, and the unit I tested is listed here with photos: https://proaudiotrade.com/products/meyer-leopard/
One last planning note: if you're starting with two cabinets, budget for the bumpers and the correct fly bars in the same order. A compact array without its rigging is a very heavy bookshelf.
Tags: audio, livesound, proaudio

Top comments (0)