Every spec sheet that lands on my desk gets the same treatment: convert the marketing numbers back into watt-hours before I read anything else. It takes thirty seconds and it usually tells you whether the range claim came out of engineering or out of a spreadsheet cell.
The example I've been working through this month is a fat-tire model, the JIUYUE S2 20in Dual Battery. Headline numbers: 48V 500W brushless rear hub motor, 48V 20Ah lithium battery, 55 km pure electric, 70 km assisted, 45 km/h top speed, 31 kg, 150 kg max load.
Start with watt-hours
48 V × 20 Ah = 960 Wh nominal. That is the only number on the page that isn't negotiable.
Now divide by the claimed range: 960 / 55 ≈ 17.5 Wh/km. For a 31 kg bike rolling on 20×4.0 tires, that is a believable figure for a moderate rider in mild weather at mixed assist. It stops being believable at 5 °C, into a headwind, with a 100 kg rider holding full throttle. The useful comparison is against a narrower tire: fat tires cost roughly 15–25% in consumption at the same speed, which explains why two bikes with different pack sizes can quote similar ranges.
The charge time tells you what charger is in the box
The sheet lists more than 12 hours to charge. Working backwards, 20 Ah of bulk charge in about 10 hours implies a charger in the 2 A class, plus a CV taper. That is a gentle charger: low heat, easy on cells, and unlikely to trip a shared 110 V circuit in an older building. The trade-off is turnaround — one full charge per night. Fine for commuters, wrong for anything shift-based.
One naming caveat worth checking
The model name says Dual Battery, but the current sheet lists a single 48V 20Ah pack. That is not unusual; model names in this trade drift faster than spec sheets do. Still, confirm it with the factory before you print packaging or list a second pack in a catalogue.
The motor is the easy part; the frame is not
A 500 W rear hub at 45 km/h is a conventional pairing and rarely where problems start. On a 20-inch fat bike, check axle nut torque, torque washers, and dropout condition on the magnesium alloy foldable frame. A folding frame puts real load through the hinge, and that hinge fails before the motor does if QC slips on a run.
Container math is a density question
The factory quotes 220 pcs per 40HQ. Fat tires eat cube, so that number is low for the category. With MOQ at 20 units and 100 units in stock in Ningbo, an LCL trial is realistic before committing to a full container — which is what I would do on any new SKU where the spec sheet is my only data.
If you want to check my arithmetic against the source, the factory spec sheet for the model I tested is here: https://ebikefactory.shop/products/jy-s2-20-dual-battery/
What goes on my incoming inspection sheet
BMS charge cut-off voltage measured against the charger's CV output, spoke tension on a 20×4.0 wheel, rotor alignment straight out of the box, hinge play after a few hundred fold cycles, and a measured capacity test on one pack per shipment rather than trusting the label.
Tags: ebike, batteries, manufacturing

Top comments (0)