DEV Community

Ohad Farkash
Ohad Farkash

Posted on

A budget electronics bench: what to buy first (and what to skip)

If you're moving from breadboard tutorials to real projects (an ESP32 sensor, a battery pack, a small amplifier), a handful of tools does most of the work. These are the ones worth buying first, roughly in order.

1. A multimeter, ideally True RMS

Voltage, continuity and resistance cover 90% of debugging. True RMS matters once you measure AC that isn't a clean sine wave. Budget meters from factory brands such as ANENG or ZOYI are fine for low-voltage hobby work. Don't use a cheap meter on mains unless its CAT rating says it's made for that.

2. A temperature-controlled soldering iron

A fixed-temperature iron oxidises tips and lifts pads. A small smart iron that heats in seconds and holds its temperature makes soldering far less frustrating.

3. A USB-C power tester

It tells you what a charger and cable actually deliver: voltage, current, and which fast-charge protocol was negotiated. It's the fastest way to find a bad cable.

4. A bench power supply with current limiting

Setting a current limit before powering a new board is the difference between "it didn't work" and "it caught fire".

5. Later: an electronic load, a BMS, a spot welder

If you build lithium packs, a proper BMS and a spot welder (not a soldering iron on the cells) are essential. An electronic load lets you test battery capacity honestly.

What to skip

Anything advertising impossible numbers, like a "1600x" USB microscope, and unbranded copies of premium tool brands.

Shipping lithium

Many sellers can't ship loose lithium cells to every country. Check the listing before you plan a pack around it.

OneFindMe keeps a ranked list of these tools, by real order counts and buyer ratings: Best Electronics Tools on AliExpress. It contains affiliate links at no extra cost to you.

Top comments (0)