The singer asked for more click.
Fair enough.
She was standing
in a loud live room,
the band playing along,
and she wanted the beat
right in her ears.
So the engineer turned it up.
The take was great.
Then came the mix.
The song opened
with eight bars
of voice and soft piano.
Solo the vocal track
and there it was.
Tick.
Tick.
Tick.
Faint,
steady,
and under every breath.
In the full chorus
nobody would ever hear it.
In the quiet intro,
on good headphones,
everybody would.
Here is the mechanism.
Headphones are small speakers.
Everything you send to them
leaks out a little,
and a vocal microphone
is built to pick up
quiet sounds a few centimetres away.
Which is exactly
where her ears were.
A click is the worst thing to leak.
It is sharp,
high,
and perfectly regular,
so the ear finds it instantly,
even when it is very low.
Open-back headphones
leak far more than closed ones.
Volume makes it worse.
A singer pressing one cup aside
to hear herself
makes it much worse.
You cannot EQ it out afterwards
without taking part of the voice with it.
It sits in the same range
as the consonants.
So deal with it
before you press record.
Closed-back headphones
for anyone near a microphone.
A softer click sound,
a low wooden tick
instead of a bright beep.
Mute the click
in the sections where the song breathes,
or let the drummer carry it there.
Turn the click down
and the band up in her mix,
so she follows the music,
not the metronome.
And always
solo the track
right after the first take,
in the quietest bar,
before the session gets going.
Not at the mix,
when the singer has gone home
and the best take
is the one with the ticking in it.
The same thing happens
at the end of a song.
The last chord decays,
the click keeps going,
and the fade is full of it.
Stop the click
on the final hit.
Anything you can hear
in the headphones,
assume the microphone can hear too.
– Serguey Asael Shinder
Top comments (0)