DEV Community

Shawn lee
Shawn lee

Posted on Originally published at reactor3d.xyz Fully Autonomous

3MF vs STL for 3D Printing Multiple Parts

Fully Autonomous / AI-generated adaptation.

This exercise compares two downloads made from the same two bodies. The editable practice project contains a 40 × 24 × 6 mm block and a cylinder 18 mm in diameter and 10 mm high. There is a gap between them. Keep the source project if you need to change those dimensions later.

Download the editable practice project (.rd).

Export the two formats

01. Open the two-part practice project

Download the editable practice file. In the Reactor 3D browser editor, choose Open project and load the RD file. Expand Gauge Block and Round Sample in the Browser to inspect their dimensions. Leave both shapes visible for a like-for-like comparison.

Gauge Block and Round Sample with their dimensions expanded in the Reactor 3D Browser

02. Export both models as 3MF

Open File → Export 3MF, select All visible models, and confirm that the count is 2. Choose Download in browser. Check the Exports section in the Browser for the completed download.

Completed 3MF export in the Browser beside the two visible sample bodies

03. Export the same models as STL

Open File → Export STL and again choose All visible models. Check that the count is 2, then choose Download in browser. Keep this export alongside the 3MF.

STL export dialog with All visible models selected and a count of two

Compare the exported files

Check 3MF STL
Units The file declares millimeters. The file stores coordinates. In the slicer, check that the block is 40 mm wide.
Object structure One mesh object with two disconnected shells in this export. One triangle mesh with the same two disconnected shells.
Print setup Choose the printer, filament, and slicing options in the slicer. Choose the printer, filament, and slicing options in the slicer.

Verify the result in the slicer

  • Open each export on an empty slicer plate and confirm that both bodies are present. Measure the block at 40 × 24 × 6 mm and look for a visible gap between the two bodies.
  • If the slicer shows one object and you need to position the pieces separately, use Split to Objects or the equivalent command. One mesh entry does not necessarily mean the shells have been joined.
  • Choose 3MF when your slicer supports it and you want an explicit file unit. Choose STL when the next tool needs triangle geometry in that format. Save a slicer project separately if you need to keep the printer, filament, supports, or plate arrangement.

Original tutorial: 3MF vs STL for 3D Printing Multiple Parts, by the Reactor 3D Team.

AI disclosure: An AI assistant prepared this adaptation from the published Reactor 3D tutorial and its original screenshots. Dimensions are CAD targets.

Top comments (0)