Linksys AC750 RE6300 extender is a networking device designed to eliminate the dead network spots issues present in your house or workplace. The WiFi extender mainly used to amplify the wireless signals transmitted out from your home WiFi router or the wireless access point.
If you have purchased a brand-new Linksys RE6300 extender, then the first question that comes in mind is 'How to perform Linksys RE6300 setup?'
If you are wondering about the same question, then you are at the right place. In the upcoming section, you will find all the possible ways to set up Linksys AC750 RE6300 WiFi range extender.
Linksys RE6300 WiFi Range Extender Setup Methods
There are two possible methods to set up Linksys RE6300 WiFi range extender:
- Manual method
- Wireless Protected Setup (WPS) method
Manual Method - Linksys RE6300 Extender Setup
Before beginning the Linksys extender manual setup, you need to consider the following requirements:
An Ethernet cable
Reliable internet connection
A desktop or laptop
Steps to Set Up Linksys Extender - RE6300
- First of all, unbox your Linksys RE6300 extender and place it near to your home WiFi router.
- Take an ethernet cable and connect Linksys RE6300 to your home WiFi router.
- Plug in the devices to a power source.
- Connect your desktop or laptop to the router's wireless or wired network.
- Run any web browser on your desktop or laptop.
- Visit http://extender.linksys.com web page.
- You land on the web-based Linksys extender admin panel.
- Enter the default Linksys AC750 extender login credentials and hit on the 'Log In' button.
- Now choose the 'Extender' mode.
- Follow the on-screen instructions to configure the WiFi range extender as per your requirements.
- Once done, hit on the 'Save' or 'Finish' button to apply the changes.
- Now, unplug the RE6300 extender and place it to a new location. Make sure you have set your WiFi range extender in a tidy area midway between your home WiFi router and the dead network zone.
- Try to connect your desktop or laptop to the Linksys RE6300 network to test the Internet connection.
Bonus Tip: Failed to visit the extender.linksys.com login web page? Try the Linksys extender default IP address. You can find the default IP address in the Linksys extender manual.
Linksys AC750 RE6300 Extender: WPS Setup
- Place your Linksys RE6300 AC750 WiFi Extender near to your home router.
- Plug it into an electric power outlet and wait until the power LED turns from blinking amber to solid green.
- Now, press the WPS button present on the side panel of the Linksys AC750 extender.
- Wait for a few minutes until the WPS LED turns from blinking to solid green.
- Now, unplug it and place it in the midway between your home WiFi router and the dead network zone.
- Try to connect your desktop or laptop to the Linksys AC750 network to test the Internet connection.
Top comments (0)