DEV Community

zjch022
zjch022

Posted on

How to Trim Audio for a Crimson Sunset Video — Free, in Your Browser

A sunset video lives or dies by its audio. If your Crimson Sunset clip has chatter before the good light, a quiet gap in the middle, or a song that outlasts the last frame, trim it first. No install is needed.

Open AudioCutter at https://audiocutter.me/. It is a free tool that runs in the browser, and your audio stays on your own device because the trimming happens locally.

Add your audio file by dragging it onto the page. MP3 and WAV both work, and the waveform shows up in a few seconds.

Drag the selection handles to keep only the part that matches the sunset footage. Play the selection back and adjust the edges until the cut feels natural.

Add a short fade-out so the music settles as the sun drops below the horizon. A fade-in at the start helps too if the recording begins with a sudden sound.

Export the trimmed clip as MP3 or WAV, then place it under your Crimson Sunset footage in your video editor. Watch the whole video once through to check the timing.

Before you share it, check four things: no stray noise at the start, no dead air in the middle, the music ends with the final frame, and the audio is loud enough on a phone speaker. If something is off, go back to AudioCutter at https://audiocutter.me/ and adjust the trim — the whole fix takes about a minute.

Disclosure: I am the developer of AudioCutter (https://audiocutter.me/), a free browser-based audio cutter. This tutorial shows how I use it for my own videos.

Top comments (0)