A fireworks show runs on a soundtrack. Each burst is timed to a beat, and the finale lands on the last big chord. If your recording is longer than the show, or starts before the first launch, trim it to fit — it takes a few minutes in the browser, with no software to install and nothing to upload.
Find the first launch and the finale
Play the recording once and note two timestamps: the moment the first firework goes up, and the final chord of the music. Everything before the first launch is dead air; everything after the finale is crowd noise you probably do not need.Trim it in your browser
Open AudioCutter and drop in your audio file. Drag the handles on the waveform to your start and end points, listen to the selection, and nudge the handles until the cut lands on the beat. Everything runs on your own device, so the file never leaves your computer.Fade the edges so the cut is invisible
A hard start sounds jarring on speakers. Add a short fade-in of about one second at the beginning and a two-second fade-out at the end, so the music swells in with the first launch and settles out as the smoke clears.Export and check the length
Export as MP3 and play the result against your video. Check that the finale chord lands on the last burst. If the timing is off by a second or two, reopen the file, move one handle, and export again — each pass takes under a minute.
Disclosure: I built AudioCutter, a free tool that trims audio in your browser. Your files stay on your device and are never uploaded.
Top comments (0)