DEV Community

zjch022
zjch022

Posted on

How to Trim Audio for a Twilight Shore Video — Free, in Your Browser

A twilight video from the shore looks calm on screen, but the audio is usually a long, uneven take: waves, footsteps, wind, and a few seconds of silence at the start. Cutting it down to the part that matters takes about a minute, and it can all happen in the browser.
Open AudioCutter — a free online audio cutter that handles MP3, WAV, M4A, and more. Everything runs in your browser, so there is no upload, no install, and no account.

How to trim it

  1. Open your audio file in the browser, or drag it into the window.
  2. Wait for the waveform, then drag the start and end handles to the part you want to keep.
  3. Preview the selection and nudge the handles until the cut sounds clean.
  4. Add a short fade in and fade out if the clip will sit under video.
  5. Export as MP3 or WAV and save the trimmed file. A small tip: leave a little extra audio at both ends on the first pass. It is easier to trim a second time than to recover audio you cut away. If the recording opens with wind noise, cut a second or two before the sound you want, then add the fade. The same workflow works for a voice memo, a podcast clip, or a song you want to shorten for a video. Trim, preview, fade, export. Disclosure: I built AudioCutter, a free browser-based audio cutter. It runs entirely in your browser: no install, no upload, no account.

Top comments (0)