Error message analysis for CentOS 6.4 and external USB drive.
The Problem
The 'Sense Key : Recovered Error' message is a generic error code that can be seen in the dmesg output of a Linux system, particularly when an external hard drive or USB device is connected. This error typically occurs due to issues with the device's hardware or firmware. It may also be caused by incorrect mounting options or configuration issues.This error can be frustrating as it might lead to confusion about the actual problem with the device. However, the good news is that this error does not necessarily mean the drive is completely faulty and can still be used for data transfer.
⚠️ Common Causes
The primary reason for this error is a hardware or firmware issue on the external hard drive or USB device. This could include a problem with the drive's motor, read/write heads, or the device's controller chip. In some cases, it might also be caused by a software issue related to the device's drivers or firmware.An alternative reason for this error is an incorrect mounting option or configuration. For example, if the drive is not properly initialized or if the file system is not correctly detected, it may cause the 'Sense Key : Recovered Error' message.
🛠️ Step-by-Step Verified Fixes
Checking and Updating Device Drivers
Step 1: Open a terminal window and type the following command to check the device drivers: `lsusb -v` This will display information about all USB devices connected to the system, including their drivers.Step 2: If the drive is recognized by the system but does not function properly, try updating the device drivers. You can do this by running the following command: `sudo yum update kernel-headers` (for RPM-based systems) or `sudo apt-get update && sudo apt-get install linux-headers-$(uname -r)` (for Debian-based systems).Step 3: After updating the device drivers, try reconnecting the external hard drive and verifying if it functions properly.
Checking and Correcting File System Configuration
Step 1: Open a terminal window and type the following command to check the file system configuration: `mount | grep sde1` This will display information about the mounted filesystems, including the device file `/dev/sde1`.Step 2: If the file system is not correctly detected, try remounting the drive with the correct options. You can do this by running the following command: `sudo mount -o order=2,errors=remount,rerror -t ext3 /dev/sde1 sde1` (for RPM-based systems) or `sudo mount -o order=2,errors=remount,rerror /dev/sde1 /mnt/sde1` (for Debian-based systems).Step 3: After remounting the drive with the correct options, try reconnecting it and verifying if it functions properly.
💡 Conclusion
If you are still experiencing issues after following these steps, it may be necessary to investigate further. You can try running a diagnostic test on the external hard drive using tools like `hdparm` or `dd`. If the problem persists, it may be best to consult with a professional for further assistance.
Full step-by-step guide with screenshots: Read the complete fix here
Found this helpful? Check out more verified tech fixes at TechFixDocs
Top comments (0)