A phone sold new in the European Union now has to carry one sentence about its charger, in its instructions and on a label on the box. The wording is set in law: "the power delivered by the charger must be between min" a figure in Watts "required by the radio equipment, and max" a second figure "in order to achieve the maximum charging speed". The manufacturer fills in the two numbers.
For a phone about to spend months on a shelf, recording and plugged in around the clock, that is the most useful line on the packaging, and the lower number is the one that matters. I read the directive that created it, then went back over our own advice on powering a phone camera. One tip in it now needs a check it did not have when it was written.
None of this is legal advice and I am not a lawyer. It is a close reading of one EU directive, aimed at people who are about to choose a power supply for a phone that will not be unplugged.
Where the sentence comes from
The rule is Directive (EU) 2022/2380, usually called the common charger directive. It does not stand alone. It amends the Radio Equipment Directive, 2014/53/EU, which is why the law keeps calling a phone "radio equipment". The amendment adds a new annex, Annex Ia, and that annex does three things.
First, it says which products are covered. The list starts with "handheld mobile phones", then tablets and digital cameras, and runs on through headphones, e-readers, keyboards and mice to laptops at the end.
Second, it sets the hardware rules. A covered device that charges over a wire has to "be equipped with the USB Type-C receptacle", and that receptacle "shall remain accessible and operational at all times". A device that charges at more than 5 volts, 3 amps or 15 watts has to "incorporate the USB Power Delivery" protocol.
Third, it sets the information rules: the sentence above, a label that shows the same numbers in graphic form, and a pictogram that tells you whether a charger is in the box.
The dates are in Article 2. Member States had to apply the rules "from 28 December 2024" for phones and the other small devices, and "from 28 April 2026" for laptops. So the label is something you will find on phones placed on the EU market from the end of 2024 onwards, and not on the handset that has been in a drawer since 2021.
What the minimum figure means
The annex tells the manufacturer what the two numbers stand for. In the label rules, the first figure is "the minimum power required by the radio equipment to charge, which determines the minimum power that a charging device needs to supply to charge the radio equipment". The second is "the maximum power required by the radio equipment to achieve maximum charging speed".
That much is what you would expect. The more interesting definition sits further up, in the recitals, the numbered paragraphs at the start of the directive that explain what the articles are for. Recital 6 says what the minimum is made of:
"The minimum power should express the sum of the power required by the radio equipment to maintain operation and the minimum power required by its battery to start charging."
That is two things added together. Part of the minimum is the power the phone uses just to stay running. The rest is what the battery needs before it begins to take charge at all. The maximum is built the same way: "the sum of the power required by the radio equipment to maintain operation and the power required to achieve the maximum charging speed."
Read that with a phone camera in mind. A phone on a shelf that records all day does not sit there just charging. It is running the whole time it is plugged in. The directive's minimum already counts some running power in. So a charger rated below the minimum is, by the manufacturer's own declared figure, below what the phone needs to keep operating and start charging at the same time.
What the minimum does not tell you
There is a gap here, and the text does not close it. The phrase "maintain operation" is not defined in the directive. It does not say whether the screen is on or off, whether the radios are busy, or whether the camera and video encoder are running. A phone recording continuously and sending a live view over Wi-Fi is doing a lot more than a phone sitting idle on a charger. Nothing in the directive says which of those states the manufacturer measured when it chose the figure.
So the honest reading is narrow. The minimum on the label is a floor declared by the manufacturer. A charger below it is outside what the manufacturer says the phone needs. A charger at or just above it is inside the declared range, but the declaration does not promise that the phone's battery will hold steady under a camera workload. Whether it does is something you find out by watching the battery level over a day or two of real recording, not by reading the box.
The advice of ours this touches
An older piece of ours on round-the-clock recording gives this tip: "If you have a choice of chargers, use the small old 5W one, not the fast charger." The reasoning in that piece is about heat: "Slow charging generates noticeably less heat, and a phone that is only maintaining its charge does not need speed."
The heat argument still stands, and the directive does not address heat at all. What the directive adds is a lower bound on how small that small charger can be. If a phone's label says its minimum is above what the old brick delivers, then the manufacturer is telling you that brick sits below the range the phone was designed for. The tip should come with a check: use the smallest charger that is still at or above the label's minimum, and look at the label before deciding what counts as small.
For phones without the label, which includes most phones old enough to be retired into camera duty, the directive gives you nothing. The next place to look is the manufacturer's own specification page or the original manual. If neither gives a minimum, a day of recording on the charger you intend to use, with the battery level noted morning and evening, is the measurement that settles it.
What USB PD on the label means
The label also shows the letters "USB PD" when the phone supports USB Power Delivery. For a phone that charges at more than 15 watts, supporting it is not optional, because point 3 of Part I applies. And the annex goes further than requiring the protocol. The phone must ensure that any additional charging protocol "allows for the full functionality of the USB Power Delivery referred to in point 3.1, irrespective of the charging device used."
In plain terms, a fast-charging phone cannot reserve its full charging behaviour for its maker's own brick and shut a standard USB PD charger out. The instructions should also say "USB PD fast charging" where this applies.
The annex also offers a one-line description of what USB PD is for: "a protocol that negotiates the fastest delivery of current from the charging device to the radio equipment without shortening the battery lifetime." That sentence is the legislator's description of the protocol, written into a labelling rule. It is not a measurement, and the directive cites no test for it. I would not lean on it as evidence about battery wear in a phone held at full charge for months.
For a phone camera the practical point is simpler: a newer phone showing "USB PD" can run from a USB PD charger whose output reaches the label's minimum, without hunting down the original brick.
The pictogram, and the box without a charger
The other graphic is the pictogram, set out in Part III of the annex. It has two versions, one for a box with a charger in it and one for a box without. Article 3a requires that it "shall be printed on the packaging or affixed to the packaging as a sticker", and that in an online shop it is shown "close to the price indication". The annex sets its minimum size: the dimension "a" in the drawing "shall be greater than or equal to 7 mm".
The same article is the reason the pictogram exists. If a seller offers a covered phone together with a charger, the seller "shall also offer the consumers and other end-users the possibility of acquiring that radio equipment without any charging device." When a phone arrives without a charger, the label with the minimum and maximum is the directive's answer to the obvious next question, which is which charger to use instead. Recital 16 says the label is meant to let buyers "determine the most appropriate charging device needed to charge their radio equipment".
There is a dated piece of this still to come. Article 47(3) says that "By 28 December 2026" the Commission shall report on the impact of selling equipment without chargers and cables, and that the report shall be accompanied, if appropriate, by a proposal to introduce "mandatory unbundling". I have not seen that report, and I do not know what it will recommend. Anything you read about mandatory unbundling before it appears is a guess.
A detail about security cameras
Recital 14 contains a sentence that reads oddly from where I sit. It explains that the digital camera category covers "any digital photo and video camera, including action cameras", and then carves something out: "Digital cameras designed exclusively for the audiovisual sector or the security and surveillance sector should not be required to integrate the harmonised charging solution."
So a camera built only for surveillance can ship with whatever charging port its maker chooses. A phone doing exactly the same job on a shelf by the front door is still a handheld mobile phone in the eyes of the directive, and it carries the USB-C port, the PD rules and the label. For anyone repurposing a handset, that works in your favour. On a newer phone, the charging information you need is printed on the box, while a camera built only for surveillance may sit outside the harmonised charging rules altogether.
A recital is not an operative article. It explains how the articles are meant to be read, and the exact scope of that carve-out is a question for the national rules that implement the directive. I am reporting what the recital says, not how any regulator applies it.
A short check before you plug it in for good
This is the order I would go in, for a phone that will live on a charger:
- Find the label. It should be on the box and in the instructions for a phone placed on the EU market from late 2024. The directive also allows the information to be given by QR code in addition, so a code on the box may lead to the same figures.
- Read the minimum. That is the floor the manufacturer declares for running plus starting to charge.
- Read the charger. The output printed on the brick is given in volts and amps, sometimes with a wattage. Make sure the wattage it can deliver is at or above the phone's minimum.
- Look for USB PD. If both the phone's label and the charger say USB PD, the phone's fast-charging protocol cannot lock that charger out.
- If there is no label, use the manufacturer's specification page or the original manual, and if neither helps, measure: note the battery level at the start and end of a full day of real recording on the charger you plan to use.
- Keep the heat advice. The smallest charger that clears the minimum is still a reasonable choice for a phone that only needs to hold its charge.
What I could not settle
I did not find a manufacturer page that reproduces the full sentence with its figures, so I cannot show you a real phone's numbers here. The label itself is a drawing in the Official Journal, and the actual figures are on the boxes. I also cannot tell you how manufacturers choose "maintain operation" when they work out the minimum, because the directive does not say and I have not seen a published method. And the rules apply in the EU. A phone bought in the US or the UK may not carry the label at all.
What is settled is narrower and still useful. For a phone sold new in the EU since the end of 2024, the lowest charger power the phone is designed for is a published figure, printed on the box. For a phone that will run on that charger for months, it takes less time to read than to find the brick.
Try it: Background Camera RemoteStream on Google Play records with the screen off and keeps the footage on the phone. Setup notes and other write-ups are at superfunicular.com.
Sources. Directive (EU) 2022/2380 on EUR-Lex, which amends the Radio Equipment Directive and inserts its Annex Ia. Quotations from the directive are verbatim from that page as read on 6 November 2026; the quotation from our earlier article is verbatim from its published text. The old brick in the drawer has its own output printed on it, and that figure belongs next to the one on the box.[shadow_engine] SHADOW_ENGINE_NO_EXPORT set — snapshot NOT written
Top comments (0)