Configure simple settings in the storage account.

The data in this storage account doesn’t require high availability or durability. A lowest cost storage solution is desired.

This Article will guide on how to setup a Simple Storage Account
Carefully follow through!

[Step 1]

In your storage account, in the Data management section, select the Redundancy blade. Note: You must have an existing Storage Account to do this.

• Select Locally-redundant storage (LRS) in the Redundancy drop-down.
• Be sure to Save your changes.
• Refresh the page and notice the content only exists in the primary location.

[Step 2]

The storage account should only accept requests from secure connections

• In the Settings section, select the Configuration blade

• Ensure Secure transfer required is Enabled.

[Step 3]

Developers would like the storage account to use at least TLS version 1.2.

• In the Settings section, select theConfiguration blade.
• Ensure the Minimal TLS version is set to Version 1.2.

[Step 4]

Until the storage is needed again, disable requests to the storage account.

• In the Settings section, select the Configuration blade.
• Ensure Allow storage account key access is Disabled.
• Be sure to Save your changes.

[Step 5]

Ensure the storage account allows public access from all networks

• In the Security + networking section, select the Networking blade.
• Ensure Public network access is set to Enabled from all networks.
• Be sure to Save your changes.